Need a couple Group bbqs

2025.02.01 19:31 TropicalShoe Need a couple Group bbqs

91SMBB
submitted by TropicalShoe to unioncircle [link] [comments]


2025.02.01 19:31 Fr3ddi_ Am I girlfriend material?

Am I girlfriend material? submitted by Fr3ddi_ to TrapCuties [link] [comments]


2025.02.01 19:31 Basic_Strawberry_101 Using Chatgpt for handloading instead of using my brain

Nowdays, everyone use Chatgpt
So I asked it to summarize the handloading process and troubleshooting of my current issue
Dose it sound legitimate?
——————-
6.5 Creedmoor Reloading Process & Troubleshooting Guide (Optimized for Aero Solus Bolt Action, PRS/F-Class Shooting)

  1. Brass Preparation
1.1 Initial Inspection
Visually inspect brass for cracks, dents, or any deformation.
Pay close attention to primer pockets and case heads for signs of overpressure.
1.2 Cleaning Primer Pockets
Remove carbon buildup using a primer pocket brush or uniforming tool.
Ensure consistent seating depth for primers.
1.3 Annealing (To Maintain Consistent Neck Tension & Case Life)
Use a torch and drill method, heating the neck for 6-8 seconds.
Ensure even heating to prevent inconsistent case hardness.
If using Tempilaq, target 750°F on the neck.
1.4 Case Cleaning
Solution: Lemi Shine + Dish Soap + Water Rinse thoroughly and dry in a convection oven.
Avoid ultrasonic cleaners or media tumbling (to prevent residue buildup).
1.5 Case Trimming, Chamfering & Deburring
Trim cases to a consistent length to ensure uniform chambering.
Chamfer the inside of the case mouth to facilitate smooth bullet seating.
Deburr the outside of the case mouth to remove any sharp edges and ensure consistent neck tension.
1.6 Final Brass Inspection
Check overall condition after trimming, chamfering, and deburring.
  1. Resizing & Neck Tension Control
2.1 Full-Length Resizing
Set die to bump the shoulder -0.002” for smooth chambering.
Use Hornady Match Die with a .290" bushing (or test .288" for better neck tension).
2.2 Neck Cleaning (To Ensure Smooth Bullet Seating)
Brush inside the neck to remove carbon fouling.
Lubricate slightly if necessary.
2.3 Expanding Mandrel for Consistent Neck Tension
Use L.E. Wilson 6.5mm expanding mandrel to ensure uniform neck tension.
If neck tension is inconsistent, test different bushing sizes (.290" vs. .288").
  1. Priming
Primer Used: CCI No. 400 Small Rifle Primers
Seat primers uniformly to avoid ignition inconsistencies.
  1. Powder Charging
4.1 Powder Selection & Measurement
Powder Used: H4350 (41.5gr) Dispensing: Lyman Gen 6 Powder Dispenser (±0.1gr tolerance)
Verify powder weight manually to ensure consistency.
  1. Bullet Seating & Cartridge Assembly
5.1 Bullet Selection & Seating Depth
Bullet Used: Hornady ELD-M 140gr
Cartridge Overall Length (COAL): 2.940"
Bullet-To-Ogive (BTO): 2.225"
Adjust BTO for optimal jump distance and consistency.
  1. Final Inspection & Storage
Check COAL & BTO consistency.
Store cartridges in a dry, temperature-controlled environment.
  1. Troubleshooting & Optimization
Issue: High ES/SD (Extreme Spread & Standard Deviation)
Possible Causes & Fixes:
✅ Inconsistent Neck Tension → Use smaller bushing (.288") to increase tension.
✅ Uneven Annealing → Ensure uniform heat distribution during annealing.
✅ Powder Charge Variations → Verify consistency in Lyman Gen 6, ±0.1gr accuracy.
✅ Different Brass Lot → Stick to the same lot of Alpha Brass.
✅ Environmental Factors (Temperature/Humidity) → Track shooting conditions.
Issue: Velocity Fluctuations Despite Consistent Charge
Possible Causes & Fixes:
✅ Bullet Seating Depth Variability → Ensure BTO remains exactly 2.225”.
✅ Primer Pocket Inconsistencies → Clean and uniform primer pockets.
✅ Powder Lot Change → Compare old vs. new H4350 lot performance.
Issue: Inconsistent Groups or Vertical Spread Possible Causes & Fixes:
✅ Seating Depth Issues → Test BTO ±0.005" adjustments for optimal jump.
✅ Barrel Fouling → Clean bore and check for excessive carbon buildup.
✅ Chamber Pressure Differences → If pressure signs appear, verify case head expansion.
  1. Next Steps & Testing Plan
1️⃣ Test .290” vs. .288” bushing & compare ES/SD results.
2️⃣ Re-test with same brass lot & ensure consistent annealing process.
3️⃣ Verify powder charge & chrono results before adjusting seating depth.
4️⃣ Experiment with BTO 2.225” ±0.005” to fine-tune precision.
This process ensures consistent velocity, minimal ES/SD, and reliable precision for PRS & F-Class shooting.
——————
Should I need to follow this AI instruction?
I think yes to me…
submitted by Basic_Strawberry_101 to reloading [link] [comments]


2025.02.01 19:31 Costanza2704 What is this?

What is this? We saw this walk around San Antonio. What is this?
submitted by Costanza2704 to sanantonio [link] [comments]


2025.02.01 19:31 JennaChips Thoughts?

Thoughts? submitted by JennaChips to Robot_Juice [link] [comments]


2025.02.01 19:31 EximiusDK Zero a iron sight

Is there any way to zero an iron sight in this game? Does anyone know of a mod that allows this, or are there any guns where it is possible?
I participate in competitions, and I’m used to aiming just below the black circle
submitted by EximiusDK to H3VR [link] [comments]


2025.02.01 19:31 Environmental-Ask358 How do you think the 1st victim could become the first blackened?

Maybe Wolfgang would think that everyone would become a despicable murderer eventually and try to get everyone killed. I can imagine this happening if he was targeted for murder but the attempt wasn’t successful, BUT he never found out who tried to kill him. I think him just killing Diana in a drug-induced rage is kinda boring and it’s fun to theorize how his mindset would break 🤪
submitted by Environmental-Ask358 to ProjectEdensGarden [link] [comments]


2025.02.01 19:31 astralpen [For Sale] Jack White, Childish Gambino, The Drive

Rating is media/jacket. $5 media mail shipping.
Childish Gambino - Because the Internet. Pink Toes vinyl, repress. M/NM. Tiny creases on top corners. $20
Jack White - Lazaretto. Etched, Ultra. M/M $15
The Drive - Can you Feel it. 45 RPM. M/M $12
Open to trades: rock, funk, IDM
submitted by astralpen to VinylCollectors [link] [comments]


2025.02.01 19:31 Immediate-Rope8465 i made a tier list of the game's ost

i made a tier list of the game's ost submitted by Immediate-Rope8465 to UndertaleYellow [link] [comments]


2025.02.01 19:31 Certain_Pizza_4533 What is this little guy?

What is this little guy? Found this in my basement, i live in Canada. It antennas before it got squished.
submitted by Certain_Pizza_4533 to insects [link] [comments]


2025.02.01 19:31 Careless-Figure-5652 Nice code

How am i get in the building now
submitted by Careless-Figure-5652 to AmazonFlexDrivers [link] [comments]


2025.02.01 19:31 IHateDunkinDonutts Happy Dreams

Happy Dreams Sound asleep ❤️
submitted by IHateDunkinDonutts to Dachshund [link] [comments]


2025.02.01 19:31 r0mantik4 @branus András kicsoda tulképp? Ismeri valaki személyesen?

@branus András kicsoda tulképp? Ismeri valaki személyesen? Már-már fake profilnak tűnik, semmi nem derül ki kocsoda is ő IRL.
submitted by r0mantik4 to talk_hunfluencers [link] [comments]


2025.02.01 19:31 Glad-Hand4858 Starting Accutane

I’ll be starting my first dose of Accutane tomorrow. What are some tips that you all have and also what are some skincare products that I should refrain from using
submitted by Glad-Hand4858 to Accutane [link] [comments]


2025.02.01 19:31 bnb123 Inkwell has me mesmerized

Inkwell has me mesmerized This polish was the reason I decided to finally purchase Holo Taco and I have no regrets.
submitted by bnb123 to simplynailogical [link] [comments]


2025.02.01 19:31 TvKid195 How do I reset the save data without having to uninstall and reinstall the game?

submitted by TvKid195 to thesims1 [link] [comments]


2025.02.01 19:31 mjgruff Feeling lost picking the right monitor for my new PC

I recently built my first PC and am looking to upgrade my monitor. It seems like there are infinite options and I’m having trouble narrowing it down.
I use my monitor for both work and gaming. I currently have a 25” 1440p acer with a 60 Hz refresh rate. I’m mainly interested in getting a higher refresh rate for gaming.
Is there a real difference between say 144, 160, and 180 Hz? Does AMD FreeSync matter and is the premium version noticeably different?
I see this monitor at microcenter which is 270 Hz for $220 (on sale from $250): https://www.microcenter.com/product/687308/acer-nitro-vg270u-z1bmiipx-27-2k-wqhd-(2560-x-1440)-270hz-gaming-monitor
270 Hz seems very high, but it’s similarly priced to other monitors at 180 and below. Is it past the point of diminishing returns? Is there something wrong with it that I’m missing?
For context, my CPU is a Ryzen 7 9700X and my GPU is a Radeon RX 7900 GRE.
Thanks in advance for any and all advice, I appreciate it.
submitted by mjgruff to buildapc [link] [comments]


2025.02.01 19:31 CorrectIamThatGuy So I just finished a 127 page Analysis of Marineford and want to post it here, but cannot copy & paste the manga panels. Any ideas?

submitted by CorrectIamThatGuy to OnePiecePowerScaling [link] [comments]


2025.02.01 19:31 Hellatan Is there "apply these indicators to entire layout" on mobile?

I like being able to turn on/off indicators on different panes of a layout. On desktop, we have the the "Apply these indicators to entire layout" option but I can't seem to find that on mobile. Is there and I simply can't find it or is not implemented on mobile?
https://preview.redd.it/8pe2t88gxkge1.png?width=628&format=png&auto=webp&s=86d66441d0e134e097333ac912b8d350809b37e4
submitted by Hellatan to TradingView [link] [comments]


2025.02.01 19:31 LessCoolThanYou Bay City Rollers - Saturday Night (#1- 1976)

Bay City Rollers - Saturday Night (#1- 1976) submitted by LessCoolThanYou to TheHot100 [link] [comments]


2025.02.01 19:31 Thaguywholikesthings 3 Renders I made that I can't make a reason to post them individually

submitted by Thaguywholikesthings to MurderDrones [link] [comments]


2025.02.01 19:31 AccountLopsided4327 29M cooked?

29M cooked? submitted by AccountLopsided4327 to amIuglyBrutallyHonest [link] [comments]


2025.02.01 19:31 brado381 Trouble with series

Does anyone else have an issue where after watching a series for a while the next episode will fail to load, like just sit there buffering and never start. Restarting fire stick seems to solve it and then 2-3 EPs later, happens again. Using Torrentio + RD.
submitted by brado381 to StremioAddons [link] [comments]


2025.02.01 19:31 officialbigjay BOOSTS 4 BOOST I HAVE 3 LEFT

$PhoneCallShawty will send back right away! & im updating as i get them sent!
submitted by officialbigjay to chimeboost [link] [comments]


2025.02.01 19:31 Realistic-Rip1946 she really strikes me as the person to just leave the shit on the sidewalk

she really strikes me as the person to just leave the shit on the sidewalk s
submitted by Realistic-Rip1946 to briannachickenfrsnark [link] [comments]


https://yandex.ru/